Automatic Oxygen Gas Fresh Air Vacuum Crimping And Gas Filling
Gas Filling Part Description
1. Two gas filling stations are composed by two independent filling
machines. Gas filling machine has fully absorbed the advanced
filling machine technology from the Swiss Pamasol Company. So as to
accelerate filling speed and accurate measuring.
2. The measuring cylinder of inflator is made of 304 stainless
steel materials. The processing techniques and precision are the
same as the measuring cylinder of filling liquid machine.
3. The seal rings of inflator adopt CFRP skeleton rings of
tetrafluoroethylene produced by American, which located in U-groove
with stainless steel reeds inside.
4. When seal rings are normally worn in long-term operation, the
outer diameter of seal rings will automatically compensate due to
the function of reeds.
Vacuum Crimping Part Description
1. The crimping head is mainly used to seal on the corrected and
pressed valve with internal expanding mode. It needs to finish two
steps respectively. Firstly, the pressure cylinder presses valves
on the opening to make the valve rubber gasket flatten against the
opening, usually the compression is 0.2-0.3mm.
2. Then, the pressure cylinder sends a signal to inform sealing
cylinder to operate. The capper is fast, reliable, steady and easy
to adjust sealed diameter and sealed depth manually without any
|Adjustable Sealing Diameter (mm)||26.5~28.5)±0.15|
|Adjustable Sealing Depth (mm)||(0~7)±0.15|
Applicable Aerosol Can Height (mm)
|Working Pressure (MPa)||0.45~0.7|
|Maximum Air Consumption (L/min)||50|
|Maximum Filling Volume (ml)||20-500ml(liquid phase)|
|Repeat Filling Accuracy||±1.0%|
|Applicable Can Model|
|Working Pressure (Mpa)||0.45-0.8Mpa|
|Maximum Air Consumption (L/min)||60|